Custom IC for FMIC.....

[spendone]

I dont know if this is the right section but here it is......

Looking to make my own IC piping for my FMIC. My entanks face towards the motor for short route piping. Anyone happen to know the lengths of the piping that I would have to cut it down to?? Would this also be correct on the piping I need??

2 - 45 degrees (upper IC piping)
2 - U-Bends(1 for the j-pipe outlet for b16g, other for lower pipe)
1 - 90 degree (Lower pipe)

I have a 2g TB elbow so that shouldnt be an issue. I am looking to get piping for as cheap as possible (not to go over 100.00). Please help me guys. Thanks in advance.



Please move to the right section if need be. Thanks again.

 

[92awddsm]

Cant tell you the sizes you need to cut the piping but you can purchase it from www.jegs.com I spent about $80 on 2.5 mandrel bent pipe for my fmic.