Clutch install help on 2g FWD talon

[MadrussianSVT]

So I got my XTD stage 4 clutch today, I never changed clutch before, is there how to wright up somewhere? What ales should I change along with clutch and who can recerface my flywheel?

Sent from my iPhone using Tapatalk while taking a shit

 

[my dreamt dsm]

Here's a mouth full. Don't forget to subscribe. DSM OG right there!

Jafromobile's Channel - YouTube

Clutch fork if it's worn out, oem throw out bearing, pivot ball.
Check input shaft and resurface your flywheel at most mom and pops store!

 

[g4ebguy90]

Just make sure, and believe me when I say this. Use a torque wrench when tightening the pressure plate bolts. Do not over torque. I have broken 2 before, just by going hand tight with 1/4 drive wrench somehow.

Always go by the book for pressure plate bolt torque!
I also use red loctite on them.

 

[viperlp01]

Just make sure, and believe me when I say this. Use a torque wrench when tightening the pressure plate bolts. Do not over torque. I have broken 2 before, just by going hand tight with 1/4 drive wrench somehow.

Always go by the book for pressure plate bolt torque!
I also use red loctite on them.

There is no way to break a flywheel bolt on a 4g63 with a 1/4 in drive. Red lock tite is a MUST. It is better to put the loctite in the hole and then thread the bolt in. I believe it is 100fts or so on the flywheel. 24 ft lbs on the clutch.

 

[g4ebguy90]

There is no way to break a flywheel bolt on a 4g63 with a 1/4 in drive. Red lock tite is a MUST. It is better to put the loctite in the hole and then thread the bolt in. I believe it is 100fts or so on the flywheel. 24 ft lbs on the clutch.

I said PRESSURE PLATE BOLTS! or what you call.... clutch bolts.......

Jeez.

 

[MadrussianSVT]

by the way, my clutch pedal is down to the floor right now and has minimal play. Is it dead clutch or something wrong with hydraulics?

 

[MadrussianSVT]

Anyone?


Sent from my iPhone using Tapatalk while taking a shit