2G Car won't start after replacing ignition coil

[that2G98]

Hey guys I'm at a loss, so I replaced my ignition coils (4G63) and well after finally getting the injectors in the car spent probably a good 4 or 5 minutes of cranking to get it to start (with 2 or 3 times inbetween it started and ran for 15 seconds or so and died) but now it cranks right up but sounds like absolute shit. Please any help would be great.

 

[Vegas Smith]

What all did you do to the car? One of the injector connectors is probably loose.

 

[that2G98]

What all did you do to the car? One of the injector connectors is probably loose.

I've got the full build on my profile, injectors it's got 1000cc. We had to take the fuel rail off to replace the coils

 

[pauleyman]

Check your plug wire sequence

 

[that2G98]

Check your plug wire sequence

Already have but just incase can you tell me the sequence? I'm pretty sure I have right as I've done it before

 

[pauleyman]

Assuming you have stock engine management it's 4123.
On a 2gb with link I think you swap the pairs. Consult the ecm wiki

 

[that2G98]

Assuming you have stock engine management it's 4123.
On a 2gb with link I think you swap the pairs. Consult the ecm wiki

Yeah I've for Ecmlink V3. Any other ideas you could have if it's not that?

 

[pauleyman]

If it was running fine before just check that first-and get back to us. No sense guessing when you haven't even tried anything.

 

[juiced_gst]

We're the coils you replaced new? or used? Check your injector connectors to make sure they're all plugged in. Try putting in your old coils and see if the car runs.