2G Tie-Rod End replacement

[The Chazz]

Curious if anyone had a tech article regarding replacing these on a 2G, along with ball joints. Searched and haven't found anything on the 2G.

Have the separator, but it's been a pain in the butt so far.

Thank you very much.

 

[All_Boost16G]

Two Tips.

1st- Take the nut and turn it the castle way down, and hit it with a hammer, and it should pop right out.
2nd- Take a hammer and hit where the ball joint seats with whatever is above it.

Use alittle heat it will be your freind.

 

[The Chazz]

Two Tips.

1st- Take the nut and turn it the castle way down, and hit it with a hammer, and it should pop right out.
2nd- Take a hammer and hit where the ball joint seats with whatever is above it.

Use alittle heat it will be your freind.

Fantastic. I had just pulled the motor so my brain was a little fried. Thanks for your help.