2 gen piston it 1 gen motor

[bojanglesracing]

ok a guy sold me this kit for my other car. now i am building up my talon motor. before i put it in and would to do the same to it. now i found that the wrist pins are diffrent. do i need diffrent rods or wrist pins and i have not had much luck in finding where i can get what i need. can any one tell me where i can get the parts to do this. i would like to do this with out a lot of money because i have other part to get to put it back togher

 

[Opus69]

If I am translating your post correctly it sounds like you want to put 2G pistons on your 1G rods... in which case the below should help you.

From the VFAQ...

http://hometown.aol.com/rcm1061/myhomepage/auto.html

Basically you need to open the wrist pin bore up to 22mm and the pin end of the rod must be narrowed .100" to 1.040"... Print the picture in the link and bring it and the rods to your local machine shop of choice and you should be good to go.

 

[bojanglesracing]

hey thanks that was just what i was looking for