The Central Hub for DSM Community and Information

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. This is where the DSM platform history is documented and archived. Log in to help us in our mission, and to remove most ads from the browsing experience.

ecmlink

  1. smoked28

    2G X-POST -- ECU Identification and Advice?

    Hello DSMers,I bought a 95 TSI AWD over the weekend and now have it in my yard and have been tinkering with it. It has 1200 cc injectors, HX35, along with many other mods. When I bought the car, the guy pulled DSMLINK off his other car to get it to start because it apparently had a bad MAF. He...
  2. smoked28

    ECMlink ECU Identification and Advice?

    Hello DSMers,I bought a 95 TSI AWD over the weekend and now have it in my yard and have been tinkering with it. It has 1200 cc injectors, HX35, along with many other mods. When I bought the car, the guy pulled DSMLINK off his other car to get it to start because it apparently had a bad MAF. He...
  3. Wildwomper

    General Unknown chip in purchased 90 socketed EPROM

    You must be registered to see element. You must be registered to see element. You must be registered to see element. You must be registered to see element. Hello all, I recently purchased a socketed eprom ecu and I want to get this figured out before it comes in. It has four vertical boards in...
  4. akamiller

    1G MTX-L Wideband and ECMLink Issues (No Closed Loop)

    Hi All, I tinker with this car once very 2 months or so and have recently fixed all vacuum leaks and basic maintenance and was ready to begin basic tuning. One of the first steps is to take a log while in closed loop. I noticed my car was staying in Open Loop at idle. More I read I found that...
  5. Engine knock help

    ok so I have just installed ecmlink v3 in my car and decide to take it for a ride and make sure everything is good. Driving it around and pretty early the check engine light flashes while moving and I’m aware that it will flash after 5 degrees knock. So I data logged and it knocked all the way...
  6. Bo0sTeD 4G63

    ECMlink Car stalls when put into 1st gear

    1). Any boost, vac, or exhaust leaks? Boost leak tested 5psi above your max boost with no leaks? No2). Verified mechanical timing? Yes3). Verified base timing? Yes4). Ignition system COP or Stock Coil: Stock Wire brand and Age: NGK, 3 Months Old Spark plug brand, type and Gap: NGK BPR7ES...
  7. lasershark

    Resolved ECM Link stops capturing randomly (Freezes)

    So while trying to data log, so I can tune for the new turbo setup, the computer just stops/freezes. It never records the same amount of time before it stops data logging. Sometimes it will record 90sec other times I will only get 20secs, never the same amount and it is making tuning a...
  8. ECMLink V3, Can't get car to idle...

    What's up party people!? New to the tuning game and it's starting off about as expected... can't get my car to idle You must be registered to see element.-2g gsx running ecmlinkv3 -1g swap, plug order switched -non 95/96 CAS checked -3" gm maft set to aux4 base2, everything else zeroed out...
  9. TSiBOLO

    2G Connecting AEM wideband to ECMLink

    I have my AEM digital wideband all wired up and working properly (as far as I can tell). The sensor is installed on my test pipe in front of the rear o2 sensor. I am trying to tune for speed density right now before I throw in ID 1050X's, Fuel lab FPR, AEM fuel rail, comp 102s and kiggly SS...
  10. smbgsx

    432WHP But Slight Miss/Stumble @ 6500 RPM WOT (datalog)

    I just switched to e85 and had a tune done. the car pulls good and cruises very good 99% of the time. there are some issues that have started recently though including... when I go WOT I have a stumble/miss at 6500 basically on the dot everytime. the whole fuel system was just redone and I...
Support Vendors who Support the DSM Community
Back
Top