Recently I rebuilt my engine, I have gotten a first start but my engine dies after a minute or so.I am using ECMLink for tuning and tuning off of a laptop. I have watched a few videos and read a good amount of articles in relation to getting a smooth tune, general tuning and more specific...

Hey guys, new here, just hoping someone can give me a hand, I just got my car running and was doing some quick tweaks on ecm link and noticed it isn't showing any voltage, opend my ECM up found it sulfated cleaned it up, changed the capacitors and it still isn't showing voltage in ecm link, any...

Hey Guys, I'm having issues with a new DSM build!A little back story about the car, I bought the car in late 2018 with the engine removed due to issues with the block and also the transmission. When I got the car it was completely stock with no modifications. I purchased a stock rebuilt 4G63...

Hello,So I finished putting my engine back together in my 96 2G and when I went to start the car it idles well but dies after a couple of seconds. It does not turn off immediately, it starts to bog down and shuts off.I'm trying to upload a video of the issue, but I am having trouble doing...

You must be registered to see element.Wanted to give a shout out to Ricky Nichols for helping me remote tune. Ricky was very knowledgeable and very helpful.My goal this summer was to make it to the car show. Unfortunately they did not give any awards for most consecutive AAA tows or most...

Ever since I put ecmlink in my car it wont rev past 5k without stuttering. Clutch cut is set to 7500k but won't go past 5k. I have my clutch unplugged so I can start it without pushing it in. Do I need to uncheck clutch cut box?

[90 talon tsi] So I'm just wondering what tuning options I have in the future (currently doing maintenance so it'll be a week or two). I already have an EPROM so I just plan on running ECMlink.I'm in Washington, i found a place about 50 miles from where I live that said they would do it but...

Hello GuysFirst, im from Germany, so my English will not be the best. Sorry for that.And this is my Problem:Two Weeks ago i upgrated my ECM-Link firmware. From this point on, i had some Issues with it. When i drive the car, and i hit 6K RPM it will abruptly stop accelerating and the...

I recently had my Galant VR4 tuned on speed density, installed new FIC 1220's injectors, and installed MTXL Innovate Wideband gauge and a OMNI 4 bar, its tuned on pump gas at the moment (Switching to E85 soon). Now after I get the car warmed up the car seems to drive good, but after about 2...

Hello guys, I’ve had my 2G 97’ Gsx for about a year now, been a huge learning experience. I’ve finally invested time to it and got a used eprom ecu. Now I installed it ,but i need to set my settings to factory , is there a link to show me what the factory settings are? Im new to tuning software...

Hey guys, I just got an mtx-l plus. Everything that I've read mentions to use the brown wire when installing but this thing doesn't have a brown wire. Only red, yellow, white, and black. Innovatives documentation says the yellow wire is analog out. I've got a 2g with Ecmlink so I was going to do...

Hey guys, I recently upgraded my fuel system to accommodate more power. I have installed a DW 255 fuel pump(rewired), fic rail and 750cc injectors, and Aeromotive fpr. I have set the fuel pressure to 42.6 or as close as I can get to it. I have tried setting the global fuel to -39.8% and global...