@steve I’ll capture the barometric pressure, sorry I didn’t see that in the earlier post. I’ll snap pictures of the engine bay maybe there is something I’m missing. I bought the car with an empty engine bay and 5gal buckets of parts, I used a...
I will purchase that cheap analog meter today and wire it to my battery, I agree the meter will be more accurate to check the battery draw. I'll go back and check all my grounds to make sure they are clean and tight. I believe the factory manual...
I've attached a new log from today. I cycled the throttle from closed to wide-open before trying to start. I reinstalled the 2G maf and attached a few pictures of the 1g to 2g maf adapter. I clean the spark plugs off and ran a compression check...
I performed the ECU reset, now the car will not start again. What is the possibility my timing could be off but still be able to run when it did? I keep racking my brain why it will not run when I have spark and fuel. I have a feeling the two...
Hey, Steve thank you for looking at my Log, I will reset the ECU today, Do I lock in open loop mode after the reset? As far as the fuel tab setting I noticed the -39.8 not sure what I did there, I noticed it last night when I removed my computer...
I just updated the ECM with the new software and the car will stay running on its own! She doesn't run all that well but she will idle for the most part. I posted a log of the car running but not sure where to go with it now.
Yes the injectors get power when the key is on, the injectors are brand new, and the ECU was sent out and tested at ECM link , I had to have the eprom socketed. I haven’t tried the starter fluid in a while, but I do recall it running for a few...
I haven't checked the compression, it's a completely rebuilt long block, I should check it while the plugs are out to confirm. I'll post my logs tonight or tomorrow. I'm away from the car today. Thank you guys for taking the time to read my post.
Since last July I replaced months old fuel with fresh fuel, I removed the plugs and clean them with start fluid and let the cylinders dry out. I replaced the MAF with a spare I bought with a Injen intake. I locked out the coolant and intake temp...
Hey Guys, I'm having issues with a new DSM build!A little back story about the car, I bought the car in late 2018 with the engine removed due to issues with the block and also the transmission. When I got the car it was completely stock with...