Wire and hose locations for 4g63

[John Mark Dongon]

So someone took my engine apart but never came back to put it together, I'm going to put it back together myself as soon as I get my new pistons in, but the wires and hoses are scattered all over the place and I have no idea which goes where!!!

 

[Mello]

That entire block needs to come out & at minimum gat a good cleaning. Its probably time for a full check over & rebuild. After you get the head on a lot of the wires & plugs will be easier to figure out & leave you with less questions with what's left.

This thread will help too. https://www.dsmtuners.com/threads/2g-engine-bay-electrical-connections.298047/

 

[Techn0Nut1996]

^ was going to paste the same link, but you barely beat me to it! Great minds think alike..

 

[John Mark Dongon]

That entire block needs to come out & at minimum gat a good cleaning. Its probably time for a full check over & rebuild. After you get the head on a lot of the wires & plugs will be easier to figure out & leave you with less questions with what's left.

This thread will help too. https://www.dsmtuners.com/threads/2g-engine-bay-electrical-connections.298047/

I'm going to wash the engine bay and block before I put everything back on. Thanks for the link!

 

[Mello]

Soap & water cleaning is not what I was referring to. I meant more like pulling out & rebuilding, measuring journals & cylinder bore, hot tanking, honing, probably new rings & bearings, etc., like a full rebuild. The rust alone is a problem.

 

[pauleyman]

I'm going to wash the engine bay and block before I put everything back on. Thanks for the link!

that block needs to come out and be fully disassembled.