Wideband install help

[latkins09]

So for the past 8 months iv had a plx m250 wide band O2 sitting in my closet and i finally thought id use it. But im a little confused, so heres the thing i want to use it as my main O2 as in i want it as my narrow band to so i want to connect it to me ecu. all the research iv done talked about wiring it to my ecu through certain pins, is there a way i can just use the wires off the original O2 so that i dont have to get in the car and start splicing harness wires.

Does any one have pics of there wide band wiring to the ecu. wiring isnt really my thing so i dont want to mess anything up.

 

[boost97gst]

http://www.dsmtuners.com/forums/articles-tuning-ecu/281763-2g-turbo-ecu-pinout-w-wire-colors.html

Its not that bad...... Yes, i suppose you could use the stock 02 harness and tap in to it. One of the pins goes straight to the ecu. Check out the link

 

[latkins09]

ok but what about the capacitors do i need them? and can i still use my wideband gauge while using my wide band as a narrow band? or would it not be as accurate

 

[WES_393]

Here is the PLX install guide:

http://www.plxdevices.com/InstallationInstructions/M-200_250_300UsersGuide.pdf