Viper 350HV alarm instal ??? where is the door lock wires?

[ApexVIII]

Im installing a Viper 350HV, and everything else is in and working.

i just need to run the two wires for the door locks,
in the kit there is a

Green wire = (-)Lock, (+)Unlock Output
Blue wire = (-) Unlock, (+) Lock Output


from what i read i am looking for a brown wire and a brown with a white stripe... but where are they ad what wire(blue or green) do i need to tap in to what brown wire or Brown/white

 

[force it in]

Here ya go.
1995-96 Mitsubishi Eclipse Alarm, Remote Starter, Keyless Entry Wiring Information
Constant 12V+ White Ignition Switch Harness
Starter Black/Red Ignition Switch Harness
Ignition Black/White Ignition Switch Harness
Ignition 2 Blue Ignition Switch Harness
Accessory Blue/Black Ignition Switch Harness
Tach Black/Blue Or Blue/Black Coil Pack (2 Cylinder Setting)
Neutral Safety Wire Black/White (-) PCM behind Center Console
Brake Switch Green Brake Switch
Trunk Pin Red/Green Silver Driver's Kick Panel
Parking Lights Green/White (+) Driver's Kick Panel or Fuse Panel
Head Lamp Red (-) Light Switch
Factory Disarm Green/White (-) Driver's Kick Panel
Door Trigger Red/Green (-) Courtesy Light or Driver's Kick Panel
Door Lock Brown/White (-) Behind Fuse Panel or 20 Pin Connector High Driver's Kick Panel
Door Unlock Brown (-)
Driver's Lock Blue/Black Driver's Kick Panel
Driver's Unlock Blue/Red Driver's Kick Panel
Passenger Unlock Blue/Red Passenger's Kick Panel
Horn Wire Green/Red (-) Steering Column
Windows Up LF=Green/Red, RF=Brown/Yellow
Windows Down LF=Green/Black, RF=Green/Yellow

 

[ApexVIII]

ok cool thanks so i need to put my green wire to the brown/white

 

[ApexVIII]

ok cool thanks so i need to put my green wire to the brown/white

ok i tryed that and it is not working :/ it does not unlock or lock, did i put them on backwards?

 

[ApexVIII]

can anyone help me?

 

[ApexVIII]

ok i ot it all working. for some reason i could not tap into the drives door floor wiring for the brown, and brown/white stripe.

i had to go across to the wiring harness behind the glove box for those two wires.

this thread can be closed

Thanks