SD cable how do I log Baro + IAT?

[GSLENK]

I have dsmlink setup for SD, how do I locate my omni 4bar and gm IAT for logging? They are plugged into the MAF connector via ecmtuning's pnp connector/cable

thanks

editnvm... easy. how do i change the color that each value is graphed as?

 

[snowborder714]

If they are wired, go back in the ECU Inputs screen and add them to the table at the top, making sure to click "Save pin assignments" afterwards. Here is the info from ECMTuning's website on which sensor will be on which input pin.

This cable connects the IAT sensor to the factory Intake Temp input pin and the MAP sensor to the factory Baro input pin. So when configuring the ECMLink software, those are the pins you'll need to specify and use.

 

[92AWDHX40]

http://www.dsmtuners.com/forums/articles-electrical-wiring/377567-wiring-logging-gm-iat-sensor.html

sd101 [ECMTuning - wiki]

try forums on ecmtuning.com