2G OBD II port not working

[Savage8960]

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

I checked all the fuses and replaced still no power does anyone know what I have to do to get power so I can pull codes my transmission is in Limp mode.. my code reader works in my other vehicle not getting any power from my DSM.

These were both together, the white one was clipped with the black one with one wire running to it.
help please

 

[Brembo]

Checked the power and the ground for ecu to start. Pull the diagram and identify the power and ground on the pins obd connector. Check continuity on the communication lines and identify all modules on the circuit. Remove one at a time to see if communication will restore.

 

[steve]

I believe the white one is the flash connector.

Have you checked pin 16 for battery voltage on the OBD2 connector?

 

[Savage8960]

I will be checking pins in morning been a busy day wil post updates

 

[steve]

And? It's been a year, even I could find time to check and reply in that time.