O2 Sensor Wire Disconnected

[neuralracing]

I was at the muffler shop today installing my Turbo Back. I noticed that the O2 sensor is not connected (I wonder if maybe when the shop was taking the heat shield and all the other stuff off to install the Evo III housing the wire popped loose). Where does it go? I left the car there until Monday since they did not finish the rear section of the exhaust.

Can someone show me some diagrams of where to connect the wire?

 

[zilo900]

if you are talking about the front o2 sensor plug, that connects right around where the coolant thermostat is, almost right below the valve cover breather if i remember correctly, it should be the same for a 1g. hope that helps

 

[HighPsi92GST]

There is a clip on the water pipe right under the T-stat housing that the other end should be stuck in yet. If not, its more then likely laying on top of the trans.
good luck

 

[neuralracing]

When I said wire I didnt mean it had lost its clip... the wire is still attached to its clip... where does that clip go?

Just under the Breather Valve on the valve cover?

 

[HighPsi92GST]

No, the clips is down under the thermostat right where the trans meets the block.