my gauges

[r1991_4g63t]

Ive had several people ask how i got my gauges like they are so decided to just post it up here incase anyone else wants to know.

eBay Motors: i702 90-94 EAGLE TALON TURBO 145MPH WHITE GLOW GAUGES (item 300243234056 end time Jul-21-08 21:58:35 PDT)

they are very easy to install. oil pressure is the only tricky one, ask and ill explain. not as bad to look at as most people would think beings they are bright blue

 

[boostngsx]

how long did the install take?

 

[r1991_4g63t]

about 45 minutes, took longer to get the cluster in and out of the car than it did to actually install the faces and wire it

 

[4g63Powered]

You should toss up the "issues" with the oil pressure gauge for future reference.

 

[r1991_4g63t]

i didnt take any pics when i did them unfortunatly but here are installed pics with them during the day and at night

You must be logged in to view this image or video.

You must be logged in to view this image or video.

the 1 trick i mentioned has to do with the oil pressure gauge.....

and you CAN see the needles, for some reason i turned the dimmer down before i took the pic

 

[93_tsi_fwd]

I have these also, but after the install, my fuel gauge started breaking up. sometimes it works sometimes not. they look good tho.

I dont know if you took your time installing it or what but I got mine all done in less than half an hour.

 

[r1991_4g63t]

the intructions say to take out the 2 screws next to each needle, which you do. what they fail to tell you is you need to take the oil guage out of the cluster first, because those 2 screws arent so little in that guage and hold everything together. theres just 2 screws holding it in, you'll know which ones im talkin about when you see them.

I have these also, but after the install, my fuel gauge started breaking up. sometimes it works sometimes not. they look good tho.

did you get the face on straight? not rubbing on the needle shaft? or did you move the needle at all during install?

 

[93_tsi_fwd]

When i got it on, it was slightly bent and the needle on the RPM and MPH were rubbing agaist the face but I put double sided tape to hold it straight.

i took out all the needles when before i put it on. it was a bi*** getting them all lined up tho.

 

[r1991_4g63t]

When i got it on, it was slightly bent and the needle on the RPM and MPH were rubbing agaist the face but I put double sided tape to hold it straight.

i took out all the needles when before i put it on. it was a bi*** getting them all lined up tho.

you obviously didnt read the directions, your not supposed to TOUCH the needles let alone remove them, and the 2 screws next to each needle hold them in place perfectly as long as everything is lined up