MAFT Tuning with a Scanmaster 3

[HBWaterfowler]

I was wondering if there was anyone out there that is using a MAF Translator and turning the MAFT with the Scanamster 3?

I'm about to put the MAFT on, and I just got the Scanmaster. I'm going to buy the wideband in a few weeks.

So is there a easy way to tune the MAFT? I was think the best way would be drive around in logging mode and collect data. Then look at the data and tune the MAFT biased on the Scanmaster. Also look at live trim/knock and adjust with that.

What's the best way to get a tune with the MAFT and Scanmaster 3?

Thanks.

 

[HBWaterfowler]

IMPORTANT: Note that the base knob gets leaner as you go clockwise, and the rest of the knobs go richer in a clockwise direction, and leaner in a counterclockwise direction.

Good info I found.