Innovate MTX-D Boost/Shift light map sensor wiring question

[stroh]

I wanted to use Ecmlink to log my new boost gauge. There are 3 wires coming out of the map sensor. Black which is the ground. Then there is a blue wire and a yellow wire. Anyone know which one I need to splice so I can log it in link? Thanks.

 

[bucken13]

hey bud i know this is a old post but i see you are a active member how did you like that boost gauge?

 

[stroh]

I like the boost gauge. It's nice having boost and a shift light. I would recommend it.

 

[Type1DSMr]

I know this is an old thread but someone may know the answer. Which wire did you use to connect to ecmlink and did you use pin 73? Also which wire is used to connect to the red wire for the shift light, was it pin 58?

 

[Type1DSMr]

Does anyone know the answer to my question on which wires connect to where?