Good maft settings or no

[brandonclum]

Ok guys 1g fwd auto tsi

I have a v2.01 maf t im waiting to buy some 650 injectors (income taxes) so for now im using the 450 injectors that actually are bigger than my auto 390 or what ever they are. i have a 16g turbo with stock boot off it. here is the question is i have it set to OFF OFF for mode 3" GM MAF, base is at 2. when checking the fuel ratio im sky rocketing up to rich. My rpms wont allow me to go above 2k rpm in this setting so i put everything to 0 and it allowed me to go to 2.5 k rpm. What is a good setting for the maft on 450cc injectors 16g turbo and stock pump ( i know the pump needs to be replaced to a higher 255 walbro and i cant figure these intructions out that came with it greek to me)

 

[clipto]

You got a wideband right? There is no "good" setting you just need check and make sure it all dial and running good, every car is different. A logger would be good but you can't go that route sorry I am not a maft fan I know people been talking about maft2.0 or whatever but its dead technoligy imo. Try get a palm logger or something too.

 

[brandonclum]

I figured it out the reason i had the problems was due to a bad coil pack... im an idiot i know should have beed the first thing i tested...

 

[92AWDHX40]

Grab a wideband.