The Central Hub for DSM Community and Information

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. This is where the DSM platform history is documented and archived. Log in to help us in our mission, and to remove most ads from the browsing experience.

gas pump thinks my tank is full when it's not..?

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Korndogg

15+ Year Contributor
471
0
Jun 21, 2003
randolph, Vermont
hey all
here's what i've experienced.. normally i fill my tank, then drive until it's empty.. i don't just throw in a buck or two whenever i need to go somewhere like some people do..

three gas station stops ago, i put $25 into my tank which is when the gas pump handle released, signalling that i'm full. this was after running my tank low enough to see the gas light (first time i've seen it..)
i was confused however, when the needle only went up to 7/8ths..
i then drove 200 miles at which time my needle was down to the E.. 200 is low, even considering 7/8ths of a tank.. but i was also driving hard because of my new bov/uicp
the next time i got gas, the gas pump handle released after almost $8 of gas... which got my about 1/4 of a tank.. i got gas again today and it released at $8 again, but i kept squeezing it until i had $10..

my question is; why would the gas pumps think i'm full when i'm not?
the only think i can think of is that i have a blockage in the line running to my tank causing gas to back up....

does anyone have any other ideas?


also, while poking aruond looking for anything odd, i seem to smell the faint scent of gas in my rear/passenger wheel well..

and maybe unrelated, but when i tried to get my car inspected a month or so ago, i failed because of like three sensors that they didn't like.. i think one was evap, another may have been O2... i'm not sure though
i can dig up the slip tomorrow...

thanks for any help :)
 
DSM gas gauges are notorious for being flakey. You may have a sender that's hitting the tank wall on its way to being full.

Your pump nozzles probably don't like the angle they're in at, and are getting just the right turbulence to shutoff. For real fun, try filling a car sometime when the shutoff fails. Nice, dangerous mess.

I notice when I fill mine, it often takes five minutes for it to bring the needle all the way to full.
 
yeah.. but it couldn't have been my gas gauge, because i drove 200 miles and then it would only take $8.. so i know something's not right

today i put $20 in it though... odd... not sure what's going on..

but yeah, my needle takes quite a while to come up too..

anyway.. i guess i'll post again if the problem comes back..
 
Add Value - Be Respectful - No Trolling - No Misinformation - Participate Often!
Support Vendors who Support the DSM Community

Build Thread Updates

Latest Classifieds

Back
Top