ECMlink Cranks but doesnt start Tune Help

[crazyquik22023]

i'm looking for some help on a tune. My car tries to crank but doesnt start. I'm looking for just some basic help with dsmlink to try to get my car started. mods: pte 1000cc's, 255 fuel pump, weisco pistons, eagle rods, pte6262, stock MAF through 4" intake, stock MAP sensor. Any info would be appreciated thanks.

 

[twdorris]

Running a 1995 ECU in a car without a 1995 style cam angle sensor requires that you swap the plug wires. The following page has more information.

1995 Plug wire swap

Hope that helps,

Thomas Dorris

 

[jeffo]

Did you check the box in "MISC" for a non-1995/96 CAS?
If you check that box, swap the plug wires as Tom instructed, set the injector scaling to ~-52%, and the deadtime to 315 or 330uS, it should fire right up.

 

[crazyquik22023]

ok car is firing up good now but it has a hard time revving past 3k and a really rough idle and i have a DTC 0100 code. Any general ideas of what i should have the timing around?? also any ideas on how to fix the code its a maf problem i believe.. also i'm wondering why i am not getting an A/F reading on my log

oh and here is a log

You must be logged in to view this image or video.