Crank sprocket removal?

[ninjadave]

First off I've seen other pully DIY forums but haven't found exactly what I'm looking for, so sorry in advance if this is a repost. Okay, so I'm having an issue with removing not the crank pully, but the sprocket behind it. So I'm gonna say the balance shaft sprocket? How can I go about removing that? The reason is because there has been a balance shaft elim. Kit installed but the bearing were not installed so I have to remove the front case but having trouble getting the "sprocket" off that rest behind the crankshaft pully. Any suggest would be appreciated. I've tried heating and using a puller and no luck just braking more stuff.

 

[pauleyman]

The harmonic balancer came off with 4 bolts. You did remove the big bolt in the center after that? After that bolt is removed there is nothing holding the sprockets on the shaft. They just slide on over the key.

 

[ninjadave]

Yes, the center bolt is removed. They could just be very snug on the key then cause I've tried a lot to pull them off and no budge.

 

[jayson427]

is there any kind of snap ring? depending if everything is off you might have to heat it up a little bit if its that tight.
i googled it and heres the link. http://www.dsmtuners.com/forums/cyl...0232-crank-sprocket-removal-installation.html

its easier to google things you dont know then it will link you to a thread on here or another forum. read the vfaq on your issue and you will figure it out.

found another link that might help as well.

http://www.dsmtalk.com/forums/showthread.php?t=54145

 

[ninjadave]

Thanks a lot, much appreciated man.