can someone tell me how to do the home depot camber mod?

[daR3alEddieJ]

I have been searching for a tech article but to no avail....anyways I ordered an spc camber kit but they only sent me enough for one corner, so I have decided f*ck it and I just want to do the home depot camber mod, which I am guessing you just put washers under the brackets on the control arms? but i dont know for sure, I have eibach pro kit springs btw, so if anyone could point me in the right direction it would be muchly appreciated...

 

[RoryBarron]

Here ya go! If that link doesn't work go to VFAQ.com and look under the suspension tab. It's near the bottom.

 

[daR3alEddieJ]

Here ya go! If that link doesn't work go to VFAQ.com and look under the suspension tab. It's near the bottom.

word. thanks homie!

 

[luv2rallye]

Make sure you use bolts long enough to fully engage the frame's thread accounting for the number of washers used. I ended up adding more washers which reduced the amount of thread engaged and they ripped out after some hard cornering. There is a lot more force there than you realize. And seriously try to get the 10.9 hardness - I ended up going to Catapiller to get them. Whatever you do don't get less than 8.8's.