can i run this stock?

[stocker97tsi]

so im looking into buying a 7 bolt long block, with the following:
bored .0020 over
-eagle H-beam rods
-9:1 Wiseco pistons
-ACL Race Bearings
-ported 2g head with a Cometic gasket
-ARP head and Main studs
-3g lifters
-ported intake manifold with 1g Throttle body(60mm)
-Crower Valve Springs, Rev out to about 8800rpms
What would i need to run this? as far as injectors, or a fuel management/fuel pump, or could it be run as is..thanks

 

[JayRolla]

If you keep the boost stock, you will be fine. You wont beable to turn it up at all with the high compression.