1G Base Injector Data for FIC 775?

[rdeis]

Got my new FIC 775 High-Z injectors installed today, yea!

ECMlink website is down, boo! It'll start, but idle isn't stable.

What are the base Global Fuel and Global Deadtime deadtime settings I need to start with?

The injector data sheet shows much more than 775 tested flow, if I use the calculator should I use the tested value or the design flow value?

 

[chrisman287]

baseinjectordata [ECMTuning - wiki]

www.ecmtuning.com

 

[rdeis]

baseinjectordata [ECMTuning - wiki]

www.ecmtuning.com

Thanks! got it

 

[rdeis]

Turns out I needed this and a bit more. Just the values in this table got it to run, but it wasn’t very stable.

I reached out to FIC and got the InjBatteryAdj table values from them and they also suggested a -35 Global Fuel with no Global deadtime. That didn’t work either.

But the combination of adjustment/deadtime from the ECMLink table and the FIC InjBatteryAdj table seems to have done the trick.

Now to finish knocking out the rest of the little nits, couple more tiny boost leaks, need to make sure my fuel pressure is stable, etc, etc.