AFC settings help.

[red98gst]

OK, I'm in a small arguement of how the settings on my afc should be for the mods I have. Can someone throw their opinion in on this.

I have an injen intake, greddy type s bov, apex'i downpipe, apex'i catback, afc, and was running around 17 psi on the T25. What should my settings on my afc be? Last time I posted on here asking this, everyone said they should be still set at 0. Is this still correct?

 

[liquordrunk]

YES leave them at zero you dont have fuel mods so there is no reason, unless you left those mods out of your profile which i havent looked at

 

[red98gst]

Nope, those are the only mods I have done. The reason I asked is because a shop is not wanting to warranty a motor they installed for me after somehow it was running very lean. They are saying its because I had the settings at 0 and didn't have more fuel going into it. Funny thing is, I ran the original motor with my mods with the afc 0 all the way across for over 2 years

 

[CanadianTSi]

With about the same mods I had my S-AFC at -5% in the upper rpm range.