??? about 6 bolt timing and filter adapter for external oil cooler

[custom240sx]

Is there a plate or something that goes behind the crank pulley that is used to time the motor, like the crank angle triggle plate of the 2 gens. Because there are no marks i can find on the pulley and the only marks i can find are on the t belt cover. Also what are the sensors that go on the oil filter adapter. The one that i bought from Machv that is tapped for the external oil cooler. What year does that come off of. Thanks for any help.

 

[BUCK]

For Timing Marks other than those on Lower Cover.

http://www.vfaq.com/mods/timingbelt-1G.html

or...

http://www.vfaq.com/mods/timingbelt-2G.html

I think your new OFH is probably a '90 - Still has a port for the Oil Pressure Switch & Oil Pressure gauge Sending Unit like any Turbo OFH, but it has a Low Oil Temp Oil Cooler Cutoff Valve.

 

[mustg5]

my OFH is made for an external oil cooler, just got done running my oil lines to and from cooler and installing oil press and oil temp senders in the OFL........the wires going by it are for your stock oil press guage and your low oil idiot light sender.....as far as the timing mark on the crank look right in the middle of the crank pully, there is a very very small notch, fell with your finger slowly and u should be able to feel it.......other wise take a look at this link.....see if it helps......good luck

http://www.vfaq.com/index-main.html