94 6bolt swap first logs

[codym]

Hey fellas, I got my ECMlink cable in today and finally was able to make some logs. I am logging using TunerProRT, not the best of methods but it's what I have at the moment.

One thing I have noticed is I don't see a total fuel trim, just o2 trim. I recently installed 450s, and have the injector size set to 480cc on the MAF-T, due to my higher stock fuel pressure(48) than the turbo guys.
Running on 91 Octane

Anyways here is the logs I made today, in case the file name doesn't come out they are listed from..


-45-50mph cruise

You must be logged in to view this image or video.

Beginning of the log was a bit choppy, had a few hills in the area as well which didn't help.

You must be logged in to view this image or video.

Got everything smoothed out towards the end

You must be logged in to view this image or video.

-4th Gear 2k-5k

You must be logged in to view this image or video.

-60% Throttle from 2nd gear

You must be logged in to view this image or video.

-WOT from 2nd 2k

You must be logged in to view this image or video.

 

[codym]

Made a few more pulls tonight.

0-40 cruise didn't look too bad, Think I just need to play around with the safc and MAFT to get my fuel trims closer to 100.

You must be logged in to view this image or video.

Had a drop in o2 volts..

You must be logged in to view this image or video.

Going into closed loop

You must be logged in to view this image or video.

While doing a 80% throttle pull, I noticed in the log during 2nd gear the RPM started climbing slower mid-gear.

You must be logged in to view this image or video.

I highlighted the area in the log, and found my o2 volts were 4.95! Any ideas what would cause that?

You must be logged in to view this image or video.