420a spun rod bearing

[amatthews]

i spun a rod bearing after the oil leaked out of the oil pan from a bad gasket. i was wondering what all i should do to the engine and if you guys could help me find an affordable solution to rebuilding it.

 

[Cdc1221]

6 will probably be fine. I would definitely not go over that on a budget built motor

 

[amatthews]

so i can run 6 psi on stock rods and pistons?

 

[92AWDHX40]

I did a rebuild stock under 1000 bucks, i get some good deals on those parts though, still under 500 bucks for everything. Depends on what is being rebuild or replaced too.