2g datalogger NO AIR FLOW reading

[SuperSlowGST]

I am new to the datalogger scene. I am trying to get a feel for what everything is on it and the numbers it reads out. Problem is I caN'T get any reading on my air flow rate. I have done a little research and checked the maf connection and wires and it still does not read. Have cleand honeycomb with contact cleaner and took ecu out to look at it and it looks fine from what I can tell but again I am new to the electronics part of things. I would research more but I am dealing with a sick wife with a long term illness and I only have little time for my car(my time for a break in things) Car is a 2g and profile is pretty accurate. Any help as to what steps to take will greatly be appreciated. BTW datalogger is a Palm3e with OBD gauge software. Thanks again

 

[SuperSlowGST]

Is this in the wrong forum?

 

[Dsm 95 Tsi Awd]

Yes you are in the right forums.

I also have a data logger. The only thing i would check is make sure you dont have any pins bent on the connector of the logger. Other than that, the car could be running right, just there isnt an accurate enough reading.

-Alex

 

[SuperSlowGST]

It's running terrible. It is not getting any reading at all on the datalogger and hits fuel cut as soon as it starts to boost good. No boost leaks. I am just about sure that this has something to do with it. I will check the pins on the datalogger ASAP. Have already checked them on the maf connection. Thanks for replying. Anybody else with a similar issue?

 

[Dsm 95 Tsi Awd]

If it is not boost leak at all, i would try replacing the spark plug wires or the spark plugs themselves.

-Alex

 

[SuperSlowGST]

I'm wanting a reading on my airflow on my datalogger. I have new NGK wires and NGK iridiums also new mitsu coil pack.