1g has no spark

[DSMsleeper630]

I was driving down the highway and my car suddenly just stalled on me. i had it towed to a repair shop and they said it wasnt getting any spark and said it could be the crank position sensor or the ignition module so i replaced both of them on my own and still no spark. I have had other people look at it and they can not figure out what it could be. Also switched it coil packs and still nothing. Any ideas of what else it could be?

 

[pauleyman]

Did you check the timing belt? If the belt isn't moving the CAS isn't turning. How about ECU? Did you look there? Any CEL codes?

 

[DSMsleeper630]

I havent checked the timing belt and how do i tell if the ECU is bad. Im running DSMlink and im not sure what i need to buy to replace it

 

[Arcangel2501]

Take it out open the ecu and look and see if any of the trim lines are burnt or not connecting to the dark line on the board its self and small it and see if it smalls burnt and also plug up you dam link and check everything also check the coilpack plugs for volts and if there getting signal from the ecu

 

[3kgt2nv]

check the ecu and the mpi relay as they both can cause this issue