Temperature gauge problem

[eder-loco]

So i just got my new motor in, did the few first start ups, let it warm up . And noticed that my the engines temperature gauge was not working. It just stayed as if the car was still cold. So i connect DSMLINK and i noticed that i am getting 180f temps. and its logging them just fine.
While i was putting the motor back in the car, i hooked up all sensors that matched with everything else

Any idea why the gauge is not working?



Thanks in advance

 

[trevnasty]

the first thing i would do is cheack all my wires and fuse's and if that dosent work i would ether run the gague on dsm link or buy a new temp gague.OOO and check and see if the wires close to the plug are worn out they brack lose very easy

 

[4G63_Attack]

For the 1g's theirs a independent sensor just for the dash temp meter. I don't know if the 2G's have something like that. Try checking the water outlet neck, to see if there is any more sensors or what not that is unplug

 

[eder-loco]

As far as i can tell. On the water neck there is only one sensor coming out of there.
If i unplug it, it stops logging on dsmlink. But once i connect it again. it starts logging again.
Is there another sensors on the 2g for the gauge in the dash? It was working just fine when i took off the other engine.
which fuse would be? in the enginebay or inside?