Resolved T25 Return line bolts

[SNAKE_15]

I apologize for this question in advance. I lost the bolts that go from the return line to the turbo and from the posts I read, they are M6X1.00X16mm long. I ordered these bolts from stm, but they were to short when I tried to install them. I even went to a 20mm in length and same result. The bolt just spins on either return line side. I'm using a stock return line for a t-25 if that matters.

 

[19Eclipse90]

The original 2G bolts for the T25 are M8 x 1.25mm x 16mm long for the return line to the turbo. At the pan, they are M6 x 1.00mm x 20mm.

 

[SNAKE_15]

The original 2G bolts for the T25 are M8 x 1.25mm x 16mm long for the return line to the turbo. At the pan, they are M6 x 1.00mm x 20mm.

Stock, t-25. I see, so they are the M8X1.25X16mm long. I use lock washers correct?

 

[dc320]

make sure you use the correct size, i used the 20mm in my td05 and it bottomed out in the hole and didnt feel tight or look tight so I kept tightening and snapped it.