Starter Wire for Solenoid?

[GSXeclipsePSI]

I'm trying to start my car up now after my rebuild. And I'm not getting anything out of the starter. Other then my signal wire might need a new end put on. I found one wire I don't have hooked up and can't figure where it goes.

I think this one is it

http://www.dsmtuners.com/forums/151542290-post41.html

I don't see anywhere on the harness to plug this thing in like it is in the picture on the engine bay connections page.

It looks long enough to reach back by the starter and its connected to the starter wire loom.

So I am still searching for an answer.

I found this post.
http://www.dsmtuners.com/forums/newbie-forum/352305-where-does-these-connectors-go.html

If I disconnected when I pulled engine out why can't I find it now?

But I can't find this end

 

[cdm_sd02]

That is it, maybe the connector came off on yours. But you're looking for a black/yellow that trips the starter solenoid; And from the other end(connector) is 12v only on start.

 

[GSXeclipsePSI]

NVM found it near the thermostat housing. It comes out of that harness.

 

[cdm_sd02]

NVM found it near the thermostat housing. It comes out of that harness.

That's the one

 

[GSXeclipsePSI]

Now I'm getting no spark... its a never ending cycle with this car...

 

[1twistdtalon]

Now I'm getting no spark... its a never ending cycle with this car...

"THESE" cars

 

[GSXeclipsePSI]

"THESE" cars

Yes your more correct then me... These cars

IF anyone reading this thread wants to help me figure out my NO start, NO spark thread please provide input.


http://www.dsmtuners.com/forums/newbie-forum/358221-another-car-wont-start-no-spark-thread-ground-setup-ok.html#post152076597