Question about 3.5 Gm Maf and Maft setup

[l7inthegst]

Alright so i have a MAFT and i just recently purchased a Gm 3.5 inch Maf and i was looking at a upper intercooler pipe for the Gm Maf setup and i havent had any luck finding the piping that can support the 3.5 inch Maf all i had found were piping for the 3 inch Maf. Is there anywhere that i havent looked to purchase a UICP for the 3.5 inch or what i would rather do is make one and if i did would that be a pain in the ass?

 

[92AWDHX40]

Try dejon tool. on the vendors list.

 

[-red97rum-]

Why change your entire uicp? Get reducer couplers instead.

 

[l7inthegst]

but wont i have to buy a UICP thats made for the Gm setup? and if not how?

 

[92AWDHX40]

You can fab up your own with piping so it fits, this make take some cutting, but its only piping.

 

[everhart1121]

Why change your entire uicp? Get reducer couplers instead.

I agree. Unless you are looking to do some fab work just use a reducer. If you are on a tight budget then you caould us pcv piping till you can aford a dejon one.