Profec B help

[laserboost]

My friends and I installed my profec b today. I had been boosting at 15 w/my mbc but when we got the profec b hooked up we couldn't balance out the high boost and were stuck at using low boost and I'm limited to about 9-10 psi. Anyone have any tips on how to balance out the high boost?

 

[rsr93]

where are your lines connected to ?

1. IN
2. OUT
3. Pressure inlet to controler

make sure you set the dip switches correct on the back.

do you still have the boost solenoid in the mix(just checking)?

 

[rsr93]

you have to set the low boost first.

and then set the high boost second.

and then balance the boost out.

if you reset one of the two levels
you have to reset both if i remember correctly.