ECMlink Latest cruise and idle log

[CiscoBite1Time]

It's been a while and I addressed some boost leaks, boost controller, and rechecked my ignition timing. After all that was done I'm starting over with my idle and cruise logs. I'm trying to match my LTFT Lo/Mi and keep my combinedFT and airflowperrev in line also. The following is an idle and cruise log from this past weekend. I'm using a dead time of 420 and this is the closes I get to getting where I want them. My combinedFT and airflowperrev looks to bee good. I think I can get by with my LO/MI both not sitting at 0. Just looking for input/opinions.

Car idles and drives fine. Just want some input before doing some WOT pulls then putting it away for winter.

Thanks.

 

[BoostedBeaver]

Following the directions stated in this sticky will net you much more help from members on this site. It is this information that allows us to give the proper advice needed.

http://www.dsmtuners.com/threads/please-read-before-you-ask-for-ecmlink-dsmlink-log-advice.443297/

Robert