Installed new starter and now my turn signals don't work

[dsmdeliveryboy]

So I installed a new starter and battery terminals yesterday on my GSX and now the turn signals aren't working. I checked the fuses and they're all fine, and I didn't cut anything in the harness besides the terminals.. What could it be? My hazards also don't work. Could it be my hazard switch?

 

[90tsiawdturbo]

did you check both fuse boxes?just askin...

 

[dsmdeliveryboy]

did you check both fuse boxes?just askin...

Yep, checked the motor bay and inside the car and every single fuse was fine.

 

[1995gsx20g]

you gotta start to diag the circuit(s) with the diagram found in the FSM. start at the bottom of the page and work your way up.

 

[dsmdeliveryboy]

Fsm?

 

[1995gsx20g]

Factory Service Manual
http://www.dsmtuners.com/forums/frequently-answered-dsm-questions/324090-download-2g-service-manual.html

 

[dsmdeliveryboy]

Now the door locks aren't working and the turn signals aren't working, and the windows wouldn't work for like 5 minutes yesterday.. FML

 

[1995gsx20g]

some of these issues could be isolated to the door. have you checked out all of the wiring in the door?

pull that rubber wire loom off and look around the hinge where the wires go from the fender into the door below the vents but above the hinge limiter.

sorry i can't remember the name to anything right now.