How do I get in this last o2 housing bolt??

[2bclutch]

How do you get this o2 housing bolt in? It hits on the pipe and there's no way I can tell to angle it in?

You must be logged in to view this image or video.

 

[1990talon]

I am not positive but dosent it go in from the other side and the nut goes on that side.

Good luck,
Brandon

 

[fourreGsixty3]

The nut was on that side when I pulled my 1G o2, and 14B apart.

Dustin

 

[2bclutch]

I am not positive but dosent it go in from the other side and the nut goes on that side.

Good luck,
Brandon

It has the same problem on the other side.

 

[2bclutch]

The nut was on that side when I pulled my 1G o2, and 14B apart.

Dustin

I already tried to put the stud in there and it won't go in either.

 

[1990talon]

can you gain any clearance by pulling them apart and putting the bolt in first from the other side?

 

[fourreGsixty3]

Are you sure its the same bolt that you pulled out of that hole? It should go in fine I had a full finger width between the end of the bolt, and the o2 housing.

Dustin

 

[2bclutch]

You're right.. the guy who had the turbo before me apparently put the stud in the wrong spot. Thanks Dustin.

 

[fourreGsixty3]

Haha, no worries bro. Glad I could be of some assistance.

Dustin

 

[1990talon]

sweet glad you got it taken care of.