help need with head work and specs

[kingdaniel04]

hey guys...
i will be sending my head somewhere this week....

i decided to give my gst, a built 7bolt with ross slugs and crower rods...comp 8 1/2 all done up,arp everything b/s removed.
running 35r from sb...k

i will be spending lots of money and was wondering if anyone has had a head done with a stage 4'ish job done by what shop and how it performed and possibly on a simular set up?
thanks.flow numbers would be great if outhere. i might b beating a dead horse but i couldnt find what i was looking for and this is pretty important...
thanks....

 

[DSM90AWD]

i will be spending lots of money and was wondering if anyone has had a head done with a stage 4'ish job done by what shop and how it performed and possibly on a simular set up

All Stg4 heads (a generic term) are not created equal, nor would the same head perform the same on different setups (especially when virtually none of your setup was specified).

I think a better question(s) would be whom is a recommend performance head builder and/or what setup (cams/valves/springs..etc) would be ideal for an "X" Liter engine to run "Y" WHP and "Z" RPMs

Specific questions get specific answers, general questions invite bench racing

 

[OverboostXS]

All Stg4 heads (a generic term) are not created equal, nor would the same head perform the same on different setups (especially when virtually none of your setup was specified).

I think a better question(s) would be whom is a recommend performance head builder and/or what setup (cams/valves/springs..etc) would be ideal for an "X" Liter engine to run "Y" WHP and "Z" RPMs

Specific questions get specific answers, general questions invite bench racing

Amen.