greddy type s installation

[Richie Rich]

i searched but got nothing. i read somewhere that to install a greddy type rs bov onto the 1g flange, you could just drill holes in it and dont need an adaptor. can this be done with teh type s? also, has anyone else done this?

 

[MrBoxx]

Yes, it's been done. The Greddy bolt holes are closer together than the 1g BOV bolt holes. Some have found that it's best to offset the new Greddy holes so that you can reinstall a 1g BOV later without a hole under the valve (read: putting the the new holes directly in line with the stock ones will cause a boost leak).

 

[Killa_dsm]

Yes it can be done. And thats what I am running on my car right now. The short route was flanged for a 1g so I just drilled holes so I can bolt my greddy type-s to it. And both greddy type-s and rs have the same flange.

 

[greddyturbo19]

i searched but got nothing. i read somewhere that to install a greddy type rs bov onto the 1g flange, you could just drill holes in it and dont need an adaptor. can this be done with teh type s? also, has anyone else done this?

yea i guess that could do it. why dont you just get a greddy flange for it. oh and also just very curious how are you a proven member with only two post??? just caught my attention

 

[Richie Rich]

cool...thanks guys.
im probably a proven member because ive been registered since 05. i dont really post here. i just registered for search reasons. since joining, ive had a 92 talon but its been long gone. dont flame but i drive a turboed civic now...with the dsm bov.