fpr for garage mod setup on link?

[enriquez2000]

I get the idea behind it and know how to plumb it. My queation is in the parameters. It doesnt look as easy as setting it to 40percnt tps and 3800 rpm with the 2 columns that are there. What would my settings be if i want normal operation below 40percent and dodge mod working above that?

 

[BoostedBeaver]

I ran this setup for a while. If you have any questions after reading through this article, feel free to ask.

In a nutshell, find the TPS point at which you build 18lbs or so. Note the RPM. Now, go to the settings page and insert values slightly lower than what you recorded. The activation points will close the bottom port leading to the bottom of the diaphragm above these points.

http://www.ecmtuning.com/wiki/usenitrouscontrolsfordejontoolbovmod

 

[enriquez2000]

Looks easy enough. .. i fixed a bunch of stuff and have to adjust my mbc now.. i was at 18psi with spikes to 20 but after the throttle body rebuild it hits 25 if i get on it.. luckily i have my gauge set to beep at me at 21 and i can let off.. ill set this all up this weekend.

From what i can tell left side on link is the "on" point correct?

 

[BoostedBeaver]

The left column in link are the values that will activate the solenoid to bypass air to the atmosphere.