Fp3565

[syrushcw]

Ok this is going to sound like a stupid question but I havnt found an answer to, Does the stock manifold turbo flange need to be ported to hook up a fp3565? If no if i port the flange on the manifold and turbo will I see any better spool time?

 

[syrushcw]

mikelv I think if i go that high i might as well go all the way and get a gt42, and your car looks awesome, I just need to get mine running after 2 years

 

[Steelnation36]

wow amazing any detailed info on its performance

 

[IvanTalonPR]

I'm not sure how well the GT35R will flow, but I'm well aware of the FP3065 and what it can do.

My FP3065 on a Stroker Motor spools full boost at about 4400rpm and from then out on, it's nothing short of amazing.
The 3065 can flow 65 lbs/min, and I truley believe I can push the limits of 700hp with this turbo. We'll see soon!

Well worth every penny, I don't care what anyone says.

Well the compressor wheel on the FP3065 is rated at 65lbs/min but the GT30R tubine wheel used on the FP3065 will limit the power, even with race gas and a good very tune you are not going see more than ~570whp.

 

[IvanTalonPR]

The Garret GT37 isnt the same as the "GT37R" from AMS and other vendors,the GT37 from garret its a diesel turbo and the GT37R from AMS and the other performance shops its a T67/P-trim with the dual ball bearing center upgrade;but the FP88HTA its a new compresor wheel (like the one on the FP3582R HTA) but its a laggier turbo full boost on a Evo 2.0 around 6000rpm.

 

[syrushcw]

"This kit equipped with the AMS 37R turbo will spool up a few hunderd RPM's later than the AMS 35R turbo and has a 450whp+ potential on 93-octane pump gas. When you add race gas to the mix, in excess of 700 whp is achievable."
Not that bad like I said if I go that big I'd def go w. the GT42r

 

[mikelv]

Well the compressor wheel on the FP3065 is rated at 65lbs/min but the GT30R tubine wheel used on the FP3065 will limit the power, even with race gas and a good very tune you are not going see more than ~570whp.

I beg to differ. No offense.
Well, guess we'll see.

 

[syrushcw]

Looks like im oging to have to go with the gt35r t3 setup its a little cheaper then the FP setup
Punishment Racing
2350 Turbo Kit
360 44mm wastegate
180 oil feed and return line
115 out the bumper wastegate dump

FP
1649 turbo
400 for 7cm flange header
360 44mm wastegate
180 oil lines
115 dump kit
425 02 housing

 

[mikelv]

Good Luck man, let me know how it turns out for you!

 

[syrushcw]

I'll keep u posted no worries