6 bolt Swap Problem

[b00stedtalon2]

I just finished the 6 bolt swap in my 95 TSi. Everything is back in and the harness is all plugged in fine. I wired my CAS just how the Magnus diagram shows.

When I go to start it, nothing happens at all and the 20 amp "Engine Motor" fuse blows whenever I replace it and try to start the car again. My friend said it looked like it was smoking from my cam sensor plug/ crank sensor plug area.

Bleh, any help or ideas would be awesome

 

[absolute_DSM]

Sounds like you wired a ground to a 12V wire. Check it over again.

 

[luv2rallye]

If fuse blows (or smoke) when you just turn key to on, use the 12V light trick mentioned here: http://www.dsmtuners.com/forums/showthread.php?p=1496998#post1496998