2.3 stroker mufflers

[awd4u]

hey guy's i was just wondering how many of you out there with 2.3l strokers, what mufflers do you guys run that sound really good. not too too deep but alittle raspy. i woudlnt think the 2.0 sound the same as a 2.3? anyway, i was thinking apexi n1. other suggestions will be great. i also want the alittle bit of poping/crackling sound on decel !

 

[SOADweskey]

I'm running the Espelier cat back on mine, I had it on when I had a 2.0 and it is still on now with the 2.3 and the sound didn't really change that much. I think it is discontinued but it is very similar to an N1.

 

[TWOpointFORliter]

My Apexi N1 sounds even deeper on my 2.4 than it did on my 2.0. Not raspy at all but I do have a little "popping/crackling" on decel but not much. The apexi N1 exhausts have 2 rather large resonators on them. If you want raspy I would look for and exhaust that doesn't have any resonators.

 

[dsmmack]

Dynomax VT muffler.

The way I positioned the camera right there at the tail pipe makes it so you can hear the valve flapping and ticking worse than when you are just standing beside the car.

Dynomax VT muffler idle 4g63 DSM - YouTube

 

[Boosted98gsx]

I use a 3" magnaflow in / out

Sounds like this with my FP3's

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[canada4g63]

I use a 3" magnaflow in / out

Sounds like this with my FP3's

You must be logged in to view this image or video.

You must be logged in to view this image or video.

Hope your putting in fuel cell

 

[Boosted98gsx]

Hope you're putting in fuel cell

Why?

 

[canada4g63]

Why else would you cut were the spare is held?

 

[Boosted98gsx]

Why else would you cut were the spare is held?

Maybe because I don't like dropping my entire subframe to be able to mess with my rear differential?

 

[acdrew]

That doesnt really seem like a bad idea I would have a steel plate that can be screwed on and off where the spare goes for kinda like a quick release setup. Now you got me thinkin, creative.

 

[Boosted98gsx]

That doesnt really seem like a bad idea I would have a steel plate that can be screwed on and off where the spare goes for kinda like a quick release setup. Now you got me thinkin, creative.

Ugh, this is a .090" thick aluminum plate that is removable. It's already been made, and isn't that expensive ($135)

Home | Frontline Fabrication

But you have a 1g, your fuel tank is already in the right place, and you have enough room to drop your rear diff by itself. Why bother?