1990 1g set up into 1992 shell

[kristoph]

Hey guys,


My 90 has some really sweet parts but unfortunately the floorboards are pushed up and shes really started to rot out on me.

I am running AEM EMS v1.

I have purchased a 1992 shell in much better cosmetic condition, and this winter I plan on swaping everything over.

I am just wondering is there anything electrical I need to be aware of when doing this swap. Anything that is not compatible with the 92 shell ?
Just trying to stay ahead of the game and not miss anything when assembling

thanks for your time,

Kris

 

[Operate]

If you are swapping the whole engine harness it should be no problem, the 92 iac,tps etc... are a bit different from a 90 harness so if you use the 92 shell's harness you just need to pin out the connectors to make sure everything is where it needs to go. I have a 90 but used a 92 iac,tps,cas and had to change some wiring around but its no big deal.

 

[er82]

ignitor, coil, tachometer are different. a couple of pins may need to be swapped on the ecu because of tachometer difference, 5v vs 12v.