Hello all!About 2 months ago I ripped apart an old 1G ECU to use as an adapter harness for a Speeduino V3 DIY board, after assembling the board I went to crank over the engine and didn't see any RPM output in tunner studio. I made sure to jump the J5-6 pins to allow for hall effect sensors...

Hey y'all, It's my first time setting up a speeduino board and messing around with tunerstudio, so I'm learning as I go, since this is all new to me.I currently have these settings and engine turns on so that's good, it idles well enough that it doesn't die, drove around the block but that's...

Hello, does anyone have the right step settings for a stepper open loop settings on tuner studio?I currently have these settings on tuner studio for this 6 pin iacv (the two red middle wires are cut so it wont interfere with the speeduino board)You must be registered to see element.You...

I have 510cc yellow top injectors installed and I'm readying up to get to the tuning phase and I was wondering if any of ya'll use Tunerstudio and have the Injector characteristics settings for these injectors, especially on the injector voltage correction chart and Injector timing?This is my...

I was wondering if anyone has any info about the speeduino/arduino standalone ECU and tuner studio software. Specifically how user friendly the software is, how hands on the ECU installation is.Does the board require assembly or come with a harness that can be soldered to the factory wiring...