Been saving up for a bit for a complete engine rebuild and miss clicked and ordered 85.0 instead of 85.5, didn't even think to check until it became time to throw it together, which was past the return date. :(All rings, wristpins, snap clips are included
Rods not includedPlease help me get...
I can Not find the bolt that goes right on or in front of the Engine Timing Crankshaft Sprocket Gear so if anybody can help me out and drop a link for me to buy one or maybe the name of what it’s Called 😭 ps (lmk if you see Anything wrong 😂
This is a brand new ACL oil pump for a 7 bolt dsm I have sitting around that I no longer need. The part number is OPMB1085.$100.00 local pick up or
$125.00 shipped with fees included
so im doing my timing and the pulleys one sticks out more than the other. my question does the idler need a spacer? because the tensioner one sticks out a bit furtther. 7bolt 2g dsm
okay so basically as title reads everything hooked up no leaks cas unplugged turns the car over then it stalls. but when i plugged in the sensor it wont crank over at all. its a 95 ecu in a 98. i did the option on link for the cas. wiring is all fine persumably its plugged in ecu right and same...
hello.
new here on the dsm community.
i have manual fwd 97 gst eclipse with 7 bolt engine and my transmission case is broke from the inside ,
so i need to find new transmission.
in my country there is only 2 cars like me, so i cant find spare parts.
i found in usa transmission like i need , but...
SOLDMIVEC Conversion for DSM - I built and ran this on my auto 1g back in 2013 with the help of Kevin. It is a very efective means of getting an automatic up on a converter - It brought my combination up on the converter in ~2 seconds verses 8+ without it. I controlled it with ECMLink and I'll...
Not sure if this is the correct subform to post this inI just finished building my 1gb, put about 1000km on it and starting having clutch disengagement issues, had a couple other issues such as oil leaks, so I pulled the motor out and found the thrust bearing was completely destroyed, and...
I have a 2g with a 20g (hybrid) compressor and extruder in a 18g housing and when I boost (24psi) I always puff whitish or blueish smoke. I have pretty good shaft play(I know its bad), around a 1/4 or 3/8 of inch of play. just wondering if i will need a new turbo? I have to put oil twice a week...
hi, im looking for an engine rebuilt kit of my GST. its a 97 eclipse turbo bone stock. recently bought the car and it started throwing white smoke after in idle for a few minutes. so im looking to repair it all the way from the heart, im just tryn to find out which is a decent brand to get it...