What kind of ports do you think would go in this? If Any..

[chris_taylor123]

So This bumper came with a car I got.. I was wondering if you guys think there is some ports that fit in the top two holes?.. Im not sure why they are there.. but Im just curious to your guys thoughts.

Bottom Front bumper

You must be logged in to view this image or video.

 

[e85_4g63]

Are you talking about the location of the reverse lights on the rear bumper?

 

[2gdsm_nc]

it was cut for a large front mount ic, by the looks of it

 

[Boomdeeze]

The two holes that were cut above where the front mount goes are just cut there to allow air to flow back to the radiator. I have them on my car I personally think it doesn't look that bad.

 

[chris_taylor123]

The two holes that were cut above where the front mount goes are just cut there to allow air to flow back to the radiator. I have them on my car I personally think it doesn't look that bad.

I figured thats what was up.. but I was just curious if there was some kind of slot I could put in them.. they dont look to bad w/o but im just curious. People where asking

And no not the reverse light holes im not stupid

 

[awddarrell]

maybe you could find some rubber trim to put around the edges to clean it up a little bit but it does not look that noticeable, so untill you figure out what it is you wanna do with them, dont sweat it

 

[Misterbeechy]

yea radiator vent holes... some FMICs may block radiator and cause overheating

 

[kawgomoo]

uhh those holes are stupid. and look horrid.

it would be better to build a duct inside your bumper {like the stock one for the radiator} than to cut giant holes in the frontal area of your car.