TurboXS RFL BOV Tuning

[lordnikon_04]

I kno there are threads on how you should tune you BOV but i can't seem to find one for my situation. I have a RFL BOV, GM MAF, MAF-T, and DejonTool UIC.From the looks of it the BOV points downward off of the UIP and in the instructions i got from TurboXS it says look to see if the exhaust ports open at idle and then add discs to tune. Now 1)my BOV has no exhaust ports and 2)it points downward from the pipe so how can i see if it's opening or not. I just wanna know if anyone else has this setup and knows about how i should tune it(i know all dsm's are different and everything). I'm just looking for a point in the right direction.

 

[2tsi_auto]

put your hand over the horn to see if the rfl leeks first. when you rev the engin does the air that comes out flutters take a washer out. IF your car at ideal seems to run better when your hand is over the horn put a washer in it. I have a h34 and mine likes to leek. good luck!!!!!

 

[lordnikon_04]

thanks. anyone else w/ advice?

 

[lordnikon_04]

anyone know about how many washers i should start out w/ or just leave it w/ none