miguelmcv
Supporting Member
- 2,716
- 260
- May 3, 2009
-
Fresno,
California
Here is a t3 cast-iron manifold, its a bolt on with an HX35 housing, the manifold was cut on an angle on the head side and on the colector side as well, giving an angle to the turbo to space it away from the block and giving clearance to use the factory Holset turbine housing.
Some dsmers use a spacer bethween the head and manifold gasket it’s longer bolts to space it away, with this manifold you need nothing but bolt it down and you are set.
Looking to get $150 shipped.
323-240-2582
Miguel.
Some dsmers use a spacer bethween the head and manifold gasket it’s longer bolts to space it away, with this manifold you need nothing but bolt it down and you are set.
Looking to get $150 shipped.
323-240-2582
Miguel.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
